How To Use The Molding Machine

Molding machine, also known as open box machine is automatically completed out of the box, forming, under the end of folding folds, and now complete the next part of the tape paste, put the cardboard box to open the box, the box by a certain procedure, and tape seal After the delivery to the packing machine dedicated equipment. Automatic carton molding machine, automatic out of the box is a large number of cartons automatically out of the box, Roll Forming Machine automatically folded under the cover, automatic sealing the bottom of the tape assembly line equipment, the machine all use PLC + display control, greatly facilitate the operation is essential for automated scale production device of.

The basic parameters of the molding machine:

⑴. Nominal injection volume: In the case of empty injection, the maximum injection amount of the injection device can be reached when the injection screw or plunger is used for the maximum injection stroke. Roll Forming Machine The unit of injection is g / cm

⑵. Injection pressure: its size and flow resistance, Roll Forming Machine the shape of the product, plastic properties, plastic way, temperature and mold temperature and the accuracy requirements of the product and other factors.

⑶. Injection rate: refers to the injection time, speed

⑷. The amount of material that can be plasticized per unit of time.

⑸. The maximum clamping force that can be applied to the mold by the clamping mechanism of the injection machine.

Forming machine features

(1) molding machine computer using imported PLC computer host chip, matching LCD screen, software backup fault self-diagnosis system and error correction function, the operation more convenient, Roll Forming Machine the control program to fool-style design, no professional training can be post operation The

(2) molding machine full hydraulic drive, with the first domestic stepless hydraulic FM technology to solve the molding machine on a variety of materials and block type of fitness, improve the material density, shorten the molding cycle.

How to use the molding machine

1, select the flattening table, a steady machine, Roll Forming Machine you can pull the chassis feet to facilitate the observation of the machine panel.

2, will be hand-held sensor head plug into the panel of the socket and tighten. Note the positioning gap

3, plug one end of the power cord into the socket on the rear panel of the chassis and the other end into the power supply socket. Be sure to use single-phase three-wire power supply.

4. Open the "POWER SW." On the rear panel of the chassis, press the "SWITCHING" button on the panel, and the "Ready" (WARM UP) "green indicator will light and the machine will work. The same time as

5. Press and hold the "SETTING BUTTON" key to set the appropriate value, usually between 0.5 and 2.0 seconds.

6, the sensor head on the container cover, Roll Forming Machine press the handle on the start button, then "HEATING" red indicator light, that is heating, the sensor head do not remove, "HEATING" red light And then remove the sensor head, and so on "WARM UP" green light or the machine buzzer short "beep" prompts and then the next container can be sealed. The same time as

7, check the sealing quality, according to different materials, diameter containers and production efficiency, appropriate dressing "set button (SETTING BUTTON) button, Roll Forming Machine making the best quality sealing.