Stable Operation Performance Of CNC Press


CNC Press Working principle: the use of hob synchronous meshing to achieve the tooth surface, at the same time using the slide down to achieve synchronized movement. Only straight gears or helical gears can be machined.

CNC Press Operation:

1, strictly prohibit the use of machine tools.

2, prohibit in the machine tool's guide surface, the paint surface place the article.

3, the gear blanks must be firmly installed on the heart axis, such as the simultaneous placement of many pieces of blank, the end of the face should be close to each other, CNC Press Brake Machine no debris between the contact surface.

4. When the hob rod is mounted on the spindle, it is fastened with a tool rod fastening bolt, and after the hob is installed, the rear bearing is mounted, pressed with the platen, and finally the hob is fastened.

5, when the roll cutting different helix angle, the turret angle plate should be fastened after moving.

CNC Pressure machine is the use of CNC technology to work with the press. CNC Press Brake Machine Through the Digital program control, the input operation instruction is processed to generate microscopic instruction, which is transmitted to the servo drive device, which drives the press to run.

At present, the market has been marketed numerically controlled presses, CNC Press Brake Machine mainly used in the processing of refractories molding servo-driven electric screw press. The nominal pressure is minimum 30T, the maximum is up to 1600T.

Numerical control presses a bit to move and work two kinds of mode, under the condition of the point moving, it can be used in the mode of adjustment and the test mode, when the working state is done, after receiving the starting signal, the hitting speed and the number of blows are preset, then the work will be stopped, CNC Press Brake Machine the workpiece can be topped out, and then the next start signal is waiting.

Numerical control presses the speed, the frequency, the force stalls, the time and so on the concrete parameter can carry on the preset through the touchscreen, the servo motor receives the instruction to drive the mechanical part to complete the predetermined procedure. Servo motor has the characteristics of high control precision, low frequency characteristic, stable moment frequency characteristic, strong overload ability, stable running performance and good speed response performance, which is more stable, accurate and safe, reliable and efficient than other modes of operation.

Numerical control presses in the configuration also has the password system, CNC Press Brake Machine the operation instruction, the fault record, the fault processing guide and so on, the automation degree is high, facilitates the use. With motor braking, mechanical braking dual braking function, with the infrared grating protection function, to ensure that the pressure machine operation in the production safety. CNC Press Brake Machine Because of the characteristics of the servo motor used in the CNC press, there is basically no energy consumption in the non blow operation, so it is very environmental protection and energy saving, which is the development trend of the production and application of the press equipment.